1) The process shown in the figure, related to automatic transmission, is to check : a) Body to driven gear clearance b) Tip clearance of driven gear  c) Side clearance of both gears  d) Stator shaft bushing 2) The unit assembly shown in the figure is a/an : a) Engine oil pump  b) Transmission oil pump  c) Steering oil pump  d) Engine water pump 3) An automatic transmission slips when shifted. What is the most likely cause? a) Defective torque converter  b) Defective one-way clutch  c) Worn planetary gears  d) Open shift solenoid 4) The part (C) shown in the figure is a : a) Sun gear  b) Ring gear  c) Pinion gear  d) Carrier 5) The unit shown in the figure is a : a) Catalytic converter  b) Friction clutch  c) Torque converter  d) Final drive and differential 6) The part (x) shown in the figure is a : a) Pinion gear  b) Ring gear  c) Sun gear  d) Carrier 7) The process shown in the figure is to check : a) Second brake piston movement  b) Piston return spring  c) Piston stroke of direct clutch  d) Torque converter sleeve run-out 8) The tool (1) shown in the figure is : a) Snap ring pliers  b) Nose pliers  c) Vice grip pliers  d) Combination pliers 9) The procedure shown in the figure is to check : a) Output shaft end float  b) Output shaft run-out  c) Pinion gear thrust clearance  d) Piston stroke of direct clutch 10) Name the part (x) shown in the figure: a) Direct clutch piston  b) Piston return spring  c) Planetary gear set  d) Direct clutch drum 11) Which part redirects the oil flow in the torque converter? a) Pump impeller  b) Turbine  c) Stator  d) One-way clutch 12) To achieve overdrive in planetary gear set, the input member must be the : a) Sun gear  b) Ring gear  c) Carrier  d) Sun and ring gears  13) In planetary gear set, when the carrier is held, the gear set is in the : a) Reverse position  b) Direct drive position  c) Overdrive position  d) Reduction position 14) The process shown in the figure is to check the : a) Direct clutch drum  b) One-way clutch  c) Direct clutch piston  d) Piston return spring 15) The figure shows how to : a) Remove the clutch piston  b) Reassemble the clutch piston  c) Check the clutch piston  d) Remove the snap ring 16) The figure shows how to : a) Remove the gearbox rear oil seal  b) Remove the gearbox front oil seal  c) Remove the gearbox snap ring  d) Install the gearbox snap ring 17) Which one of the following is an automatic transmission fluid ? a) Dexron II  b) DOT 3  c) SAE 20 W - 40  d) SAE 90 18) The switch shown in the figure is a/an : a) Over drive main switch  b) Kick down switch  c) Neutral start switch  d) Oil pressure switch 19) The process shown in the figure is to : a) Install snap ring  b) Remove piston return spring  c) Remove direct clutch piston  d) Remove one way clutch 20) The torque converter is mounted on the : a) Input side of automatic transmission  b) Output side of automatic transmission  c) Input side of manual transmission  d) Output side of manual transmission

Automatic Transmission

by
Print
Embed

Leaderboard

Visual style

Options

Switch template

Continue editing: ?